Plating solutions in opened topped tanks and vats can be heated by either side entry type heaters or top entry heaters inserted into the top of the tank.
Side entry heaters fitted to the base of the tank tend to be more convenient as the elements and terminal enclosures are less likely to be damaged or become obstructive to the use of the tank. Fixed element type heaters such as our WR and WF ranges can be specified by our Technical Department. Removable core type heaters are more robust and less likely to get entangled in objects being inserted into the tank. Please refer to our HO, HF and OD ranges.
Top entry Vat heaters (RV and SH ranges) are easier to install and remove. It should be noted that only the contents of the tank above the heating elements will be heated. It is therefore important to ensure that any top entry type heaters should have elements that reach the bottom of the tank.
Where it is advantageous not to have any elements in the tank then flow heaters would be recommended.
1kW to 24kW immersion heaters for fitting to calorifiers and tanks. Single and three phase with boss sizes 1”, 1¼", 1½", 1¾", 2", 2¼" and 2½” BSP, IP66 terminal enclosure. Suitable for water heating and anti-frost applications. Can be specified to heat oils and caustics.
Building services, commercial, industrial, marine and outdoor use.
1kW to 24kW immersion heaters for fitting to calorifiers and tanks. Single and three phase with flange fixing, IP66 terminal enclosure. Suitable for water heating and anti-frost applications. Can be specified to heat oils and caustics.
Building services, commercial, industrial, marine and outdoor use.
1kW to 3kW immersion heaters for fitting to tanks. Single and three phase with boss sizes 2", 2¼", 2½” BSP. Suitable for heating oils, caustics and anti-frost applications.
Industrial and outdoor use.
1kW to 6kW immersion heaters for fitting to tanks. Single and three phase with flange fixing. Suitable for heating oils, caustics and anti-frost applications.
Industrial and outdoor use.
6kW to 24kW, removable core type immersion heater specifically for fitting to bottom of dip tanks used in surface treatment and coating. Three phase with rectangular flange, IP65 terminal enclosure. Suitable for heating water, caustic, phosphate and chemical solutions.
Industrial
Suitable for heating buried or bunded tanks including out of doors and is ideal as an anti-frost heater. Range of loadings from 1kW to 15kW for water heating applications. Can be specified to heat, oils and caustics.
Industrial.
Suitable for installation over the side of a tank. Range of loadings from 1kW to 30kW depending on solution being heated, in single and three phase, IP55 terminal enclosure. Option of fitting control and over-temperature safety thermostats. Models suitable for a wide range of chemical solutions.
Industrial.
